Displaying Log And Trace Files From The Cli - Juniper J-Series Administration Manual

J-series Services Router Administration Guide
This example displays only
mtrace
displayed—exactly as it is displayed in
Table 126 on page 244 summarizes the output fields of the display.
Table 126: CLI mtrace monitor Command Output Summary
Field
Mtrace operation-type at time-of-day
by
resp to address
qid qid
packet from source to destination
from source to destination
via group address
mxhop=number

Displaying Log and Trace Files from the CLI

You can enter the
logs and trace files:
user@host> monitor start filename
When the Services Router adds a record to the file specified by
is displayed on the screen. For example, if you have configured a system log file
named
level), you can enter the
added to the system log.
To display a list of files that are being monitored, enter the
To stop the display of records for a specified file, enter the
command.
244
Using CLI Diagnostic Commands
mtrace
response, the display is similar, but the complete
Description
—Type of multicast trace operation:
operation-type
—Date and time the multicast trace query or response was captured.
time-of-day
IP address of the host issuing the query.
—Response destination address.
address
—Query ID number.
qid
—IP address of the source of the query or response.
source
—IP address of the destination of the query or response.
destination
source —IP address of the multicast source.
—IP address of the multicast destination.
destination
—Group address being traced.
address
—Maximum hop setting.
number
command to display real-time additions to system
monitor start
(by including the
system-log
monitor start system-log
queries. When the Services Router captures an
mtrace
command output.
mtrace from-source
query
statement at the [
syslog
command to display the records
monitor list
monitor stop filename
response is also
or .
response
filename , the record
] hierarchy
edit system
command.