Juniper J-Series Administration Manual page 174

J-series Services Router Administration Guide
Table 79 on page 152 summarizes key output fields in media gateway information
displays.
Table 79: Summary of Key Media Gateway Information Output Fields
Field Values
Dynamic Call Admission Control Information
Reported Bearer Maximum bandwidth available for voice traffic
Bandwidth Limit on the Services Router.
Interface Name Name of interface on which dynamic CAC is
configured.
(See the interface naming conventions in the
J-series Services Router Basic LAN and WAN Access
Configuration Guide.)
State
Link state of the interface:
Activation Priority Activation priority configured on the interface.
Bearer Bandwidth Maximum bandwidth available for voice traffic
Limit (Kbps) on the interface.
Telephony Gateway Module Information
Media Gateway IP addresses of the MGCs configured in the MGC
Controller (MGC) List list for the TGM550.
Slot state Online and offline status of the telephony interface
modules (TIMS).
Offline Reason Reason for offline status: Busy Out or Out of
resources.
152
Using the Monitoring Tools
show tgm dynamic-call-admission-control
show tgm fpc slot-number media-gateway-controller
show tgm fpc slot-number dsp-capacity
show tgm telephony-interace-module status
Up or Down .
Additional Information
If dynamic CAC is configured on more than one
active interface, the TGM550 reports the bearer
bandwidth limit (BBL) of the active interface with
the highest activation priority.
If more than one active interface has the same
activation priority, the BBL is reported as the
number of those interfaces times their lowest BBL.
For example if two interfaces with the same
activation priority have BBLs of 2000 Kbps and
1500 Kbps, the RBBL is 3000 Kbps (2 x 1500
Kbps).
The operational state is the physical state of the
interface. If the interface is physically operational,
even if it is not configured, the operational state
is . An operational state of
Up Down
problem with the physical interface.
indicates a