Juniper J-Series Administration Manual page 154

J-series Services Router Administration Guide
Table 65: Summary of Key MPLS LSP Information Output Fields (continued)
Field Values
From Source (inbound router) of the session.
State
State of the path. It can be
Rt Number of active routes (prefixes) installed in the
routing table.
Active Path Name of the active path:
P An asterisk (*) in this column indicates that the
LSP is a primary path.
LSPname Configured name of the LSP.
Style RSVP reservation style. This field consists of two
parts. The first is the number of active
reservations. The second is the reservation style,
which can be
or
WF
Labelin Incoming label for this LSP.
Labelout Outgoing label for this LSP.
Total Total number of LSPs displayed for the particular
type—
transit
Monitoring MPLS LSP Statistics
To display accounting information about LSPs, select Monitor>MPLS>LSP Statistics,
or enter the following CLI command:
show mpls lsp statistics
NOTE: \Statistics are not available for LSPs on the outbound router, because the
penultimate router in the LSP sets the label to 0. Also, as the packet arrives at the
outbound router, the hardware removes its MPLS header and the packet reverts to
being an IPv4 packet. Therefore, it is counted as an IPv4 packet, not an MPLS packet.
Table 66 on page 133 summarizes key output fields in the MPLS LSP statistics display.
132
Using the Monitoring Tools
Up , Down , or
Primary or Secondary
(fixed filter), (shared explicit),
FF SE
(wildcard filter).
ingress (inbound), egress (outbound), or
.
Additional Information
AdminDn . AdminDn indicates that the LSP is being taken
down gracefully.
For inbound RSVP sessions, the routing table is
the primary IPv4 table (
outbound RSVP sessions, the routing table is the
primary MPLS table (
. This field is used for inbound LSPs only.
This field is used for inbound LSPs only.
This field is used for outbound and transit LSPs
only.
). For transit and
inet.0
mpls.0 ).