Juniper J-Series Administration Manual page 265

Table 125: CLI mtrace from-source Command Output Summary
Field
hop-number
host
ip-address
protocol
ttl
Round trip time milliseconds ms
total ttl of number required
Source
Response Dest
Overall
Packet Statistics For Traffic From
Receiver
Query Source
Using the mtrace monitor Command
To monitor and display multicast trace operations, enter the
user@host> mtrace monitor
Mtrace query at Apr 21 16:00:54 by 192.1.30.2, resp to 224.0.1.32, qid 2a83aa
packet from 192.1.30.2 to 224.0.0.2
from 192.1.30.2 to 192.1.4.1 via group 224.1.1.1 (mxhop=60)
Mtrace query at Apr 21 16:00:57 by 192.1.30.2, resp to 224.0.1.32, qid 25dc17
packet from 192.1.30.2 to 224.0.0.2
from 192.1.30.2 to 192.1.4.1 via group 224.1.1.1 (mxhop=60)
Mtrace query at Apr 21 16:01:00 by 192.1.30.2, resp to same, qid 20e046
packet from 192.1.30.2 to 224.0.0.2
from 192.1.30.2 to 192.1.4.1 via group 224.1.1.1 (mxhop=60)
Mtrace query at Apr 21 16:01:10 by 192.1.30.2, resp to same, qid 1d25ad
packet from 192.1.30.2 to 224.0.0.2
from 192.1.30.2 to 192.1.4.1 via group 224.1.1.1 (mxhop=60)
Description
Number of the hop (router) along the path.
Hostname, if available, or IP address of the router. If the
in the command, the hostname is not displayed.
IP address of the router.
Protocol used.
TTL threshold.
Total time between the sending of the query packet and the receiving of the response
packet.
Total number of hops required to reach the source.
Source IP address of the response packet.
Response destination IP address.
Average packet rate for all traffic at each hop.
Number of packets lost, number of packets sent, percentage of packets lost, and average
packet rate at each hop.
IP address receiving the multicast packets.
IP address of the host sending the query packets.
Chapter 12: Using Services Router Diagnostic Tools
no-resolve option was entered
mtrace monitor
Using CLI Diagnostic Commands
command:
243