Juniper J-Series Administration Manual page 246

J-series Services Router Administration Guide
5.
Figure 23: Traceroute Page
Table 112: Traceroute Field Summary
Field Function
Remote Host Identifies the destination host of the traceroute.
Advanced Options
Don't Resolve Determines whether hostnames of the hops along
Addresses the path are displayed, in addition to IP addresses.
Gateway Specifies the IP address of the gateway to route
through.
Source Address Specifies the source address of the outgoing
traceroute packets.
Bypass Routing Determines whether traceroute packets are routed
by means of the routing table.
If the routing table is not used, traceroute packets
are sent only to hosts on the interface specified in
the Interface box. If the host is not on that interface,
traceroute responses are not sent.
Interface Specifies the interface on which the traceroute
packets are sent.
Time-to-Live Specifies the maximum time-to-live (TTL) hop count
for the traceroute request packet.
Type-of-Service Specifies the type-of-service (TOS) value to include
in the IP header of the traceroute request packet.
224
Tracing Unicast Routes from the J-Web Interface
The Services Router sends a total of three traceroute packets to each router along
the path and displays the round-trip time for each traceroute operation. If the
Services Router times out before receiving a
(*) is displayed for that round-trip time.
Table 113 on page 225 summarizes the output fields of the display.
To stop the traceroute operation before it is complete, click OK while the results
of the traceroute operation are being displayed.
ERROR: Unresolved graphic fileref="s020256.gif" not found in
"\\teamsite1\default\main\TechPubsWorkInProgress\STAGING\images\".
message, an asterisk
Time Exceeded
Your Action
Type the hostname or IP address of the destination
host.
To suppress the display of the hop hostnames,
select the check box.
To display the hop hostnames, clear the check
box.
Type the gateway IP address.
Type the source IP address.
To bypass the routing table and send the
traceroute packets to hosts on the specified
interface only, select the check box.
To route the traceroute packets by means of
the routing table, clear the check box.
From the list, select the interface on which
traceroute packets are sent. If you select any, the
traceroute requests are sent on all interfaces.
From the list, select the TTL.
From the list, select the decimal value of the TOS
field.