Juniper J-Series Administration Manual page 31

Table 8: Users Quick Configuration for RADIUS Servers Summary
Field
RADIUS Server
RADIUS Server Address
(required)
RADIUS Server Secret (required)
Verify RADIUS Server Secret
(required)
Adding a TACACS+ Server for Authentication
You can use the Users Quick Configuration page for TACACS+ servers to configure
a TACACS+ server for system authentication. This Quick Configuration page allows
you to specify the IP address and secret of the TACACS+ server.
Figure 2 on page 9 shows the Users Quick Configuration page for TACACS+ servers.
Figure 2: Users Quick Configuration Page for TACACS+ Servers
To configure a TACACS+ server with Quick Configuration:
1.
2.
3.
4.
To cancel your entries and return to the Users Quick Configuration page,
click Cancel.
Function
Identifies the IP address of the RADIUS
server.
The secret (password) of the RADIUS
server.
Verifies the secret (password) of the
RADIUS server is entered correctly.
ERROR: Unresolved graphic fileref="s020242.gif" not found in
"\\teamsite1\default\main\TechPubsWorkInProgress\STAGING\images\".
In the J-Web interface, select Configuration>Quick Configuration>Users.
Under TACACS+ servers, click Add to configure a TACACS+ server.
Enter information into the Users Quick Configuration page for TACACS+ servers,
as described in Table 9 on page 10.
Click one of the following buttons on the Users Quick Configuration page for
TACACS+ servers:
To apply the configuration and return to the Users Quick Configuration page,
click OK.
To cancel your entries and return to the Users Quick Configuration page,
click Cancel.
Chapter 1: Managing User Authentication and Access
Your Action
Type the RADIUS server s 32-bit IP address, in
dotted decimal notation.
Type the secret (password) of the RADIUS server.
Secrets can contain spaces. The secret used must
match that used by the RADIUS server.
Retype the secret of the RADIUS server.
Managing User Authentication with Quick Configuration
9