Before You Begin; Managing User Authentication With Quick Configuration; Adding A Radius Server For Authentication; Adding A Tacacs+ Server For Authentication - Juniper J-Series Administration Manual

J-series Services Router Administration Guide
When you configure local user templates and a user logs in, the JUNOS software
issues a request to the authentication server to authenticate the user's login name.
If a user is authenticated, the server returns the local username to the router, which
then determines whether a local username is specified for that login name
(
the appropriate local user template locally configured on the router. If a local user
template does not exist for the authenticated user, the router defaults to the
template.
For more information, see "Setting Up Template Accounts" on page 18.

Before You Begin

Before you perform any system management tasks, you must perform the initial
Services Router configuration described in the Getting Started Guide for your router.

Managing User Authentication with Quick Configuration

This section contains the following topics:

Adding a RADIUS Server for Authentication

You can use the Users Quick Configuration page for RADIUS servers to configure a
RADIUS server for system authentication. This Quick Configuration page allows you
to specify the IP address and secret (password) of the RADIUS server.
Figure 1 on page 8 shows the Users Quick Configuration page for RADIUS servers.
Figure 1: Users Quick Configuration Page for RADIUS Servers
To configure a RADIUS server with Quick Configuration:
1.
2.
3.
4.
8

Before You Begin

for TACACS+,
local-username
Adding a RADIUS Server for Authentication on page 8
Adding a TACACS+ Server for Authentication on page 9
Configuring System Authentication on page 10
Adding New Users on page 11
ERROR: Unresolved graphic fileref="s020241.gif" not found in
"\\teamsite1\default\main\TechPubsWorkInProgress\STAGING\images\".
In the J-Web interface, select Configuration>Quick Configuration>Users.
Under RADIUS servers, click Add to configure a RADIUS server.
Enter information into the Users Quick Configuration page for RADIUS servers,
as described in Table 8 on page 9.
Click one of the following buttons on the Users Quick Configuration page for
RADIUS servers:
To apply the configuration and return to the Users Quick Configuration page,
click OK.
for RADIUS). If so, the router selects
Juniper-Local-User
remote