Configuring Rpm With A Configuration Editor; Configuring Basic Rpm Probes; Configuring Tcp And Udp Probes; Tuning Rpm Probes - Juniper J-Series Administration Manual

J-series Services Router Administration Guide
Table 140: RPM Quick Configuration Summary (continued)
Field Function
Standard Deviation Generates traps when the threshold for standard
Exceeded deviation in round-trip times is exceeded.
Test Completion Generates traps when a test is completed.
Test Failure Generates traps when the threshold for the total
number of lost probes is reached.
Performance Probe Server
TCP Probe Server Specifies the port on which the Services Router is to
receive and transmit TCP probes.
UDP Probe Server Specifies the port on which the Services Router is to
receive and transmit UDP probes.

Configuring RPM with a Configuration Editor

To configure the Services Router to perform real-time performance tests, you perform
the following tasks. For information about using the J-Web and CLI configuration
editors, see the J-series Services Router Basic LAN and WAN Access Configuration Guide.

Configuring Basic RPM Probes

To configure basic RPM probes, you must configure the probe owner, the test, and
the specific parameters of the RPM probe.
For ICMP ping, ICMP ping timestamp, UDP ping, and UDP ping timestamp probes,
you can also set a timestamp to improve the measurement of latency or jitter. The
probe is timestamped by the router originating the probe (the RPM client).
In this sample use of RPM, basic probes are configured for two customers: Customer A
and Customer B. The probe for Customer A uses ICMP timestamp packets and sets
RPM thresholds and corresponding SNMP traps to catch lengthy inbound times. The
276

Configuring RPM with a Configuration Editor

Configuring Basic RPM Probes on page 276
Configuring TCP and UDP Probes on page 279
Tuning RPM Probes on page 282
Configuring RPM Probes to Monitor BGP Neighbors on page 283
Your Action
To enable SNMP traps for this condition,
select the check box.
To disable SNMP traps, clear the check
box.
To enable SNMP traps for this condition,
select the check box.
To disable SNMP traps, clear the check
box.
To enable SNMP traps for this condition,
select the check box.
To disable SNMP traps, clear the check
box.
Type the number 7—a standard TCP or UDP
port number—or a port number from 49152
through 65535.
Type the number 7—a standard TCP or UDP
port number—or a port number from 49152
through 65535.