Monitoring Route Information - Juniper J-Series Administration Manual

J-series Services Router Administration Guide
This section contains the following topics:

Monitoring Route Information

To view the
Monitor>Routing>Route Information, or enter the following CLI commands:
Table 52 on page 116 summarizes key output fields in the routing information display.
Table 52: Summary of Key Routing Information Output Fields
Field Values
n Number of destinations for which there are routes in
destinations the routing table.
n routes Number of routes in the routing table:
—Number of routes that are active.
active
holddown —Number of routes that are in hold-down
state (neither advertised nor updated) before being
declared inactive.
hidden —Number of routes not used because of
routing policies configured on the Services Router.
Destination Destination address of the route.
Protocol/
Protocol from which the route was learned:
Preference
Direct , Local , or the name of a particular protocol.
The preference is the individual preference value for
the route.
116
Using the Monitoring Tools
Monitoring Route Information on page 116
Monitoring BGP Routing Information on page 117
Monitoring OSPF Routing Information on page 119
Monitoring RIP Routing Information on page 120
Monitoring DLSw Routing Information on page 121
inet.0 (IPv4) routing table in the J-Web interface, select
show route terse
show route detail
Static
Additional Information
The route preference is used as one of the route
,
selection criteria.