Juniper J-Series Administration Manual page 306

J-series Services Router Administration Guide
Table 144: Configuring RPM Probes to Monitor BGP Neighbors
Task
Navigate to the Services>RPM>BGP
level in the configuration hierarchy.
Specify a hexadecimal value (the range
is between and characters) that
1 2048
you want to use for the data portion of
the RPM probe—for example,
Specify the data size of the RPM probe
in bytes, a value from 0 through
65507—for example, .
1024
Configure port 50000 as the TCP port to
which the RPM probes are sent.
Specify the number of probe results to
be saved in the probe history—for
example, . The range is between
25
and , and the default is
255 50
Configure the probe count—for example,
5 —and probe interval—for example,
Probe count—Total number of RPM
probes to be sent for each test. The
range is between 1 and
default is 1 .
Probe interval—Wait time (in
seconds) between RPM probes. The
range is between and
1
the default is .
3
Specify the type of probe to be sent as
part of the test— tcp-ping .
NOTE: If you do not specify the probe
type the default ICMP probes are sent.
Configure a value between 0
seconds for the interval between
tests—for example, .
60
284
Configuring RPM with a Configuration Editor
To check the configuration, see "Verifying an RPM Configuration" on page 285.
J-Web Configuration Editor
1. In the J-Web interface, select
Configuration>View and
Edit>Edit Configuration.
2. Next to Services, click Configure
or Edit.
3. Next to Rpm, select the Yes check
box and click Configure or Edit.
4. Next to Bgp, click Configure.
In the Data fill box, type
ABCD123 .
In the Data size box, type
In the Destination port box, type
In the History size box, type
0
.
1. In the Probe count box, type
1 .
2. In the Probe interval box, type
15 and the
, and
255
In the Probe type box, select tcp-ping.
1.
and 86400 In the Test interval box, type
2. Click OK.
CLI Configuration Editor
From the
[edit]
edit services rpm bgp
Enter
ABCD123 .
set data-fill ABCD123
. Enter
1024
set data-size 1024
. Enter
50000
set destination-port 50000
. Enter
25
set history-size 25
. Enter
5
.
1
set probe-count 5 probe-interval 1
Enter
set probe-type tcp-ping
Enter
60 .
set test-interval 60
hierarchy level, enter