Juniper J-Series Administration Manual page 67

Link flags
Physical info
Hold-times
Current address: Unspecified, Hardware address: Unspecified
Alternate link address: Unspecified
Last flapped
Statistics last cleared: Never
Traffic statistics:
Input bytes
Output bytes
Input packets:
Output packets:
Input errors:
Errors: 0, Drops: 0, Framing errors: 0, Runts: 0, Giants: 0, Policed discards:
0,
Resource errors: 0
Output errors:
Carrier transitions: 0, Errors: 0, Drops: 0, MTU errors: 0, Resource errors:
0
Logical interface dl0.0 (Index 70) (SNMP ifIndex 75) (Generation 146)
Description: USB-modem-remote-management
Flags: Point-To-Point SNMP-Traps 0x4000 LinkAddress 23-0 Encapsulation: PPP
Dialer:
State: Active, Dial pool: usb-modem-dialer-pool
Dial strings: 220
Subordinate interfaces: umd0 (Index 64)
Activation delay: 0, Deactivation delay: 0
Initial route check delay: 120
Redial delay: 3
Callback wait period: 5
Load threshold: 0, Load interval: 60
Bandwidth: 115200
Traffic statistics:
Input bytes
Output bytes
Input packets:
Output packets:
Local statistics:
Input bytes
Output bytes
Input packets:
Output packets:
Transit statistics:
Input bytes
Output bytes
Input packets:
Output packets:
LCP state: Opened
NCP state: inet: Opened, inet6: Not-configured, iso: Not-configured,
mpls: Not-configured
CHAP state: Success
Protocol inet, MTU: 1500, Generation: 136, Route table: 0
Flags: None
Addresses, Flags: Is-Preferred Is-Primary
Destination: 172.20.10.1, Local: 172.20.10.2, Broadcast: Unspecified,
Generation: 134
The output shows a summary of dialer interface information. Verify the following
Meaning
information:
Chapter 2: Setting Up USB Modems for Remote Management
: Keepalives
: Unspecified
: Up 0 ms, Down 0 ms
: Never
: 13859
: 0
317
0
: 24839
: 17792
489
340
: 10980
: 17792
172
340
: 13859
: 0
317
0
Verifying Dialer Interface Configuration
0 bps
0 bps
0 pps
0 pps
0 bps
0 bps
0 pps
0 pps
45