Juniper J-Series Administration Manual page 109

From the CLI, enter the
Action
user@host> show system autoinstallation status
Autoinstallation status:
Master state: Active
Last committed file: None
Configuration server of last committed file: 10.25.100.1
Interface:
Name: ge-0/0/0
State: Configuration Acquisition
Acquired:
Address: 192.168.124.75
Hostname: host-ge-000
Hostname source: DNS
Configuration filename: router-ge-000.conf
Configuration filename server: 10.25.100.3
Address acquisition:
Protocol: DHCP Client
Acquired address: None
Protocol: RARP Client
Acquired address: None
Interface:
Name: ge-0/0/1
State: None
Address acquisition:
Protocol: DHCP Client
Acquired address: None
Protocol: RARP Client
Acquired address: None
The output shows the settings configured for autoinstallation. Verify that the values
Meaning
displayed are correct for the Services Router when it is deployed on the network.
show system autoinstallation status
Verifying Autoinstallation Status
Chapter 5: Configuring Autoinstallation
command.
87