Juniper J-Series Administration Manual page 308

J-series Services Router Administration Guide
Verifying RPM Services
Verify that the RPM configuration is within the expected values.
Purpose
From configuration mode in the CLI, enter the
Action
user@host# show services rpm
The output shows the values that are configured for RPM on the Services Router.
Meaning
Verifying RPM Statistics
Verify that the RPM probes are functioning and that the RPM statistics are within
Purpose
expected values.
From the J-Web interface, select Monitor>RPM. From the CLI, enter the
Action
rpm probe-results
user@host> show services rpm probe-results
286
Verifying RPM Services
probe test {
test customerA {
probe-type icmp-ping;
target address 192.178.16.5;
probe-count 15;
probe-interval 1;
hardware-timestamp;
}
test customerB {
probe-type icmp-ping-timestamp;
target address 192.178.16.5;
probe-count 15;
probe-interval 1;
hardware-timestamp;
}
test customerC {
probe-type udp-ping;
target address 192.178.16.5;
probe-count 15;
probe-interval 1;
destination-port 50000;
hardware-timestamp;
}
}
command.
Owner: customerA, Test: icmp-test
Probe type: icmp-ping-timestamp
Minimum Rtt: 312 usec, Maximum Rtt: 385 usec, Average Rtt: 331 usec,
Jitter Rtt: 73 usec, Stddev Rtt: 27 usec
Minimum egress time: 0 usec, Maximum egress time: 0 usec,
Average egress time: 0 usec, Jitter egress time: 0 usec,
Stddev egress time: 0 usec
Minimum ingress time: 0 usec, Maximum ingress time: 0 usec,
Average ingress time: 0 usec, Jitter ingress time: 0 usec,
Stddev ingress time: 0 usec
Probes sent: 5, Probes received: 5, Loss percentage: 0
Owner: customerB, Test: http-test
Target address: 192.176.17.4, Target URL: http://customerB.net,
Probe type: http-get
show services rpm command.
show services