Juniper J-Series Administration Manual page 296

J-series Services Router Administration Guide
Table 140: RPM Quick Configuration Summary (continued)
Field Function
Hardware Enables timestamping of RPM probe messages. On
Timestamp J-series Services Routers you can timestamp the
following RPM probes to improve the measurement
of latency or jitter:
Maximum Probe Thresholds
Successive Lost Sets the total number of probes that must be lost
Probes successively to trigger a probe failure and generate a
system log message.
Lost Probes Sets the total number of probes that must be lost to
trigger a probe failure and generate a system log
message.
Round Trip Time Sets the total round-trip time (in microseconds), from
the Services Router to the remote server, that triggers
a probe failure and generates a system log message.
Jitter Sets the total jitter (in microseconds), for a test, that
triggers a probe failure and generates a system log
message.
Standard Deviation Sets the maximum allowable standard deviation (in
microseconds) for a test, which, if exceeded, triggers
a probe failure and generates a system log message.
Egress Time Sets the total one-way time (in microseconds), from
the Services Router to the remote server, that triggers
a probe failure and generates a system log message.
Ingress Time Sets the total one-way time (in microseconds), from
the remote server to the Services Router, that triggers
a probe failure and generates a system log message.
Jitter Egress Time Sets the total outbound-time jitter (in microseconds),
for a test, that triggers a probe failure and generates
a system log message.
Jitter Ingress Time Sets the total inbound-time jitter (in microseconds),
for a test, that triggers a probe failure and generates
a system log message.
Egress Standard Sets the maximum allowable standard deviation of
Deviation outbound times (in microseconds) for a test, which,
if exceeded, triggers a probe failure and generates a
system log message.
274
Configuring RPM with Quick Configuration
ICMP ping
ICMP ping timestamp
UDP ping—destination port UDP-ECHO (port 7)
only
UDP ping timestamp—destination port
UDP-ECHO (port 7) only
Your Action
To enable timestamping, select the check box.
Type a number between 0 and 15.
Type a number between 0 and 15.
Type a number between 0 and 60,000,000
(microseconds).
Type a number between 0 and 60,000,000
(microseconds).
Type a number between 0 and 60,000,000
(microseconds).
Type a number between 0 and 60,000,000
(microseconds).
Type a number between 0 and 60,000,000
(microseconds)
Type a number between 0 and 60,000,000
(microseconds)
Type a number between 0 and 60,000,000
(microseconds).
Type a number between 0 and 60,000,000
(microseconds).