Using The Monitoring Tools; Monitoring System Properties - Juniper J-Series Administration Manual

Using the Monitoring Tools

This section describes the monitoring tools in detail. It contains the following topics:

Monitoring System Properties

The system properties include everything from the name and IP address of the
Services Router to the resource usage on the Routing Engine. To view these system
properties, select Monitor>System in the J-Web interface, or enter the following CLI
show
Table 48 on page 107 summarizes key output fields in system properties displays.
Table 48: Summary of Key System Properties Output Fields
Field Values
System Identification
Serial Serial number for the J-series Services Router.
Number
JUNOS Version of JUNOS software active on the Services
Software Router, including whether the software is for domestic
Version or export use.
Monitoring System Properties on page 107
Monitoring the Chassis on page 111
Monitoring the Interfaces on page 113
Monitoring Routing Information on page 115
Monitoring Class-of-Service Performance on page 123
Monitoring MPLS Traffic Engineering Information on page 130
Monitoring Service Sets on page 135
Monitoring Firewalls on page 136
Monitoring IPSec Tunnels on page 140
Monitoring NAT Pools on page 142
Monitoring DHCP on page 143
Monitoring RPM Probes on page 145
Monitoring PPP on page 147
Monitoring PPPoE on page 148
Monitoring the TGM550 Media Gateway (VoIP) on page 151
commands:
show system uptime
show system users
show system storage
Chapter 7: Monitoring the Router and Routing Operations
Additional Information
Export software is for use outside of the U.S. and
Canada.
Using the Monitoring Tools
107