Alarm Severity; Alarm Conditions; Interface Alarm Conditions; Chassis Alarm Conditions And Corrective Actions - Juniper J-Series Administration Manual

Alarm Severity

Alarms on a Services Router have two severity levels:

Alarm Conditions

To enable alarms on a Services Router interface, you must select an alarm condition
and an alarm severity. In contrast, alarm conditions and severity are preconfigured
for chassis alarms and system alarms.
This section contains the following topics:

Interface Alarm Conditions

Table 89 on page 168 lists the interface conditions, sorted by interface type, that you
can configure for an alarm. Each alarm condition can be configured to trigger either
a major (red) alarm or minor a (yellow) alarm. The corresponding configuration
option is included.
For the services stateful firewall filters, NAT, IDS, and IPSec, which operate on an
internal adaptive services module within a Services Router, you can configure alarm
conditions on the integrated services and services interfaces.
Major (red)—Indicates a critical situation on the router that has resulted from
one of the following conditions. A red alarm condition requires immediate action.
One or more hardware components have failed.
One or more hardware components have exceeded temperature thresholds.
An alarm condition configured on an interface has triggered a critical warning.
Minor (yellow)—Indicates a noncritical condition on the router that, if left
unchecked, might cause an interruption in service or degradation in performance.
A yellow alarm condition requires monitoring or maintenance.
A missing rescue configuration or software license generates a yellow system
alarm.
Interface Alarm Conditions on page 167
Chassis Alarm Conditions and Corrective Actions on page 170
System Alarm Conditions and Corrective Actions on page 172
Chapter 9: Configuring and Monitoring Alarms
Alarm Overview
167