Table of Contents
Advertisement
Parameter
Parameter
ssdCache
Notes
Performance modeling ends and the performance modeling data is available when one of the following
conditions occurs:
•
Run the stop ssdCache performanceModeling command.
•
Retrieve the performance modeling data using PowerVault MD Storage Manager.
Performance modeling ends, but no data is available when one of the following conditions occurs:
•
You reboot the RAID controller module.
•
You make any changes to the SSD cache configuration.
•
The state of the SSD cache changes.
Start Storage Array Blink
Description
This command identifies a storage array by turning on the indicator LED for the storage array. Use the
stop storageArray blink command to turn off the indicator LED for the storage array.
Syntax
start storageArray blink
Parameters
None.
Start Storage Array Configuration Database Diagnostic
Description
This command runs a consistency check against a configuration database.
Syntax
start storageArray configDbDiagnostic
[sourceLocation=(disk | onboard)]
366
Description
The alphanumeric identifier (including - and _) of
the SSD cache that you want to locate. Enclose the
identifier in square brackets ([ ]). If the SSD cache
name contains special characters or consists only
of numbers, you also must enclose the identifier in
double quotation marks (" ") inside square brackets.
Advertisement
Table of Contents
