Set Snapshot Group Media Scan - Dell PowerVault Manual

Parameter
Notes
You can use any combination of alphanumeric characters, underscore (_), hyphen (-), and pound (#) for
the names. Names can have a maximum of 30 characters.
When you use this command, you can specify one or more of the parameters. You do not, however,
need to use all of the parameters.

Set Snapshot Group Media Scan

Description
This command runs a media scan on a snapshot group.
Syntax
set snapGroup ["snapGroupName"]
mediaScanEnabled=(TRUE | FALSE)
consistencyCheckEnabled=(TRUE | FALSE)
Parameters
Parameter
snapGroup
mediaScanEnabled
consistencyCheckEnabled
294
Description
operation at the expense of system performance.
Valid values are highest, high, medium, low, or
lowest. A value of high indicates that the rollback
operation is prioritized over all other host I/O. A
value of lowest indicates that the rollback
operation should be performed with minimal
impact to host I/O.
Description
The alphanumeric identifier (including - and _) of
the snapshot group on which you want to run a
media scan. Enclose the snapshot group name in
double quotation marks (" ") inside of square
brackets ([ ]).
The setting to turn on or turn off media scan for
the virtual disk. To turn on media scan, set this
parameter to TRUE. To turn off media scan, set this
parameter to FALSE. (If media scan is disabled at
the storage array level, this parameter has no
effect.)
The setting to turn on or turn off consistency
checking during a media scan. To turn on
consistency checking, set this parameter to TRUE.
To turn off consistency checking, set this
parameter to FALSE.