Table of Contents
Advertisement
Parameter
-h
-I
-i
-m
-n
-o
-p
20
Definition
Use with the -a and -x parameters to specify the
host name that is running the SNMP agent to
which the storage array is connected.
Use to specify the type of information to be
included in the e-mail alert notifications. The
following are valid information arguments:
•
eventOnly— Only event information is
included in the e-mail.
•
profile— Event and array profile information
is included in the e-mail.
•
supportBundle— Event and support bundle
information is included in the e-mail.
NOTE: You can enter only one information
argument each time you execute the
command. If you want all of the information,
you must run the command three times.
Use with the -d parameter to display the IP address
of the known storage arrays.
Use to specify the host name or IP address of the
e-mail server from which to send e-mail alert
notifications.
Use to specify the name of the storage array on
which to run the script commands. This name is
optional when you use host‑name-or-IP-
address; however, if you are using the in-band
method for managing the storage array, you must
use the -n parameter if more than one storage
array is connected to the host at the specified
address. The storage array name is required when
host‑name-or-IP-address is not used;
however, the name of the storage array configured
for use in the MD Storage Manager GUI (that is,
listed in the configuration file) must not be a
duplicate name of any other configured storage
array.
Use with the -c or -f parameter to specify a file
name for all output text that is a result of running
the script commands.
Use to specify the password for the storage array
on which to run commands. A password is not
necessary under the following conditions:
•
A password has not been set on the storage
array.
Advertisement
Table of Contents
