Table of Contents
Advertisement
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the
names. Command names can have a maximum of 30 characters. If you exceed the maximum
character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation.
Set Host Port
Description
This command changes the host type for an HBA host port. You can also change an HBA host port label
with this command.
Syntax
set hostPort [portLabel] host="hostName"
userLabel="newPortLabel"
Parameters
Parameter
hostPort
host
userLabel
NOTE: When you use this command, you can specify one or more of the optional parameters. You
do not, however, need to use all of the parameters.
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the
names. Command names can have a maximum of 30 characters. If you exceed the maximum
character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation.
Set iSCSI Initiator
Description
This command sets the attributes for an iSCSI initiator.
Syntax
set iscsiInitiator (["iscsiID"]|
userLabel="newName" |
Description
The name of the HBA host port for which you want
to change the host type, or for which you want to
create a new name. Enclose the HBA host port
name in square brackets ([ ]). If the HBA host port
label has special characters, enclose the HBA host
port label in double quotation marks (" ").
The name of the host to which the HBA host port
is connected. Enclose the host name in double
quotation marks (" ").
The new name that you want to give to the HBA
host port. Enclose the new name of the HBA host
port in double quotation marks (" ").
279
Advertisement
Table of Contents
