Set Host Channel; Set Host Group - Dell PowerVault Manual

Set Host Channel

Description
This command defines the loop ID for the host channel.
Syntax
set hostChannel [hostChannelNumber]
preferredID=portID
Parameters
Parameter
hostChannel
preferredID

Set Host Group

Description
This command renames a host group.
Syntax
set hostGroup [hostGroupName]
userLabel="newHostGroupName"
Parameters
Parameter
hostGroup
userLabel
278
Description
The identifier number of the host channel for
which you want to set the loop ID.
The host channel identifier number is constructed
by combining the controller number and the host
channel number. Enclose the host channel
identifier number in square brackets ([ ]). Separate
the controller number from the host channel
number with a comma.
For example, the identifier number for host
channel 2 on controller 0 would be [0,2].
The port identifier for the specified host port. Port
ID values are 0 to 127.
Description
Name of the host group to rename. You must put
brackets ([ ]) around the host group name. If the
host group name has special characters, you must
also put quotation marks (" ") around the host
group name.
New name for the host group. You must put
quotation marks (" ") around the host group name.