Start The Storage Center Startup Wizard - Dell SC4020 Deployment Manual

Storage center
Hide thumbs Also See for SC4020:
Table of Contents

Advertisement

5.
To prevent unauthorized access to the BMC, make sure that the BMC IP address is set to a private
non-routable IP address.
a. Run the following command to view the BMC IP address.
platform bmc show
b. Run the following commands to set the BMC IP address, netmask, and gateway.
platform bmc set ip <IP address>
platform bmc set netmask <netmask>
platform bmc set gateway <gateway address>
Example:
platform bmc set ip 169.254.0.2
platform bmc set netmask 255.255.255.0
platform bmc set gateway 0.0.0.0
NOTE: Dell recommends setting the BMC IP addresses of the storage controllers in
sequential order. Using the BMC IP address of the top storage controller, set the BMC IP
address of the bottom storage controller to the next IP address in sequence.
6.
Run the following command to verify that the prejoin configuration information is correct.
platform prejoin show
If the prejoin information is incorrect, re-enter the information and verify it again.
7.
Run the following command to exit safe mode and boot up the storage controller.
-sm -go
NOTE: The storage controller might take several minutes to completely boot up. During this
time, there are long pauses that might make the storage controller appear to be idle. However,
the long pauses are part of the normal boot process. When the storage controller finishes
booting up, the following message is displayed in the terminal emulator: All subsystems
initialized successfully.
CAUTION: As the storage controller boots up, a login prompt may appear in the terminal
emulator. Do not log in to the storage controller with the Admin account at this time.
Logging in with Admin account before the storage controller subsystems are fully initialized
may cause the Admin account to become locked.

Start the Storage Center Startup Wizard

Use a web browser to log in to Storage Center System Manager and start the Storage Center Startup
Wizard.
Prerequisites
You must have a computer that has connectivity to the Storage Center management network. The
computer must have the following software installed:
One of the following supported web browsers (other browsers and versions may have limited
compatibility):
– Microsoft Windows Internet Explorer Versions 7, 8, and 9
– Microsoft Windows Internet Explorer 10 and 11 on the desktop (Internet Explorer 10 and 11 Modern
version is not supported)
– Mozilla Firefox on Microsoft Windows
The 32-bit (x86) Java 8 Runtime Environment must be installed to run Storage Center System
Manager in any 32-bit browser.
106
Set up Storage Center Software

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents