Modify Disk Pool - Dell PowerVault Manual

Parameter
Notes
Depending on the size of the database image, restoring the database might take up to 30 minutes. The
host software does not show the controllers in an optimal state till all actions for loading the database
image are completed on the controllers.

Modify Disk Pool

Description
This command adds capacity to a disk pool or changes the RAID controller module ownership for the
entire disk pool. These two operations are mutually exclusive.
Syntax
set diskPool [diskPoolName]
((addDrives=[enclosureID1,drawerID1,slotID1 ... enclosureIDn,drawerIDn,slotIDn]
| addCapacity=(addCapacityValue[KB|MB|GB|TB|Bytes])) | owner=(0 | 1))
Parameters
Parameter
addDrives
addCapacity
owner
Description
• If the parameter is set to all, all of the data
including disk pool configuration data is
retrieved.
The default is raidConfiguration.
Description
Identifies multiple physical disks to add to the disk
pool. Each disk pool must be created from a
minimum of 11 physical disks specified. There is no
upward limit of physical disks supported in a single
disk pool, but the number cannot exceed the
number of physical disks supported on the storage
array.
Use the addCapacity parameter to specify the
amount of storage and automatically select
physical disks to meet that capacity.
The RAID controller module that owns the disk
pool. Valid RAID controller module identifiers are 0
or 1, where 0 is the RAID controller module in slot
0, and 1 is the RAID controller module in slot 1. If
you do not specify an owner, the RAID controller
module firmware determines the owner.
227