Resume Snapshot Image Rollback - Dell PowerVault Manual

Syntax
resume asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"]
[deleteRecoveryPointIfNecessary]
Parameter
Parameter
asyncRemoteReplicationGroup
deleteRecoveryPointIfNecessary

Resume Snapshot Image Rollback

Description
This command resumes a rollback operation that has entered a paused state. A rollback operation can
enter a paused state due to processing errors, which causes a Needs Attention condition for the storage
array.
If the rollback operation cannot be resumed, the selected snapshot virtual disk reverts to a paused state,
and the Needs Attention condition is displayed.
NOTE: You cannot use this command for snapshot images involved in online virtual disk copy.
Syntax
resume snapImage [snapImageName] rollback
Parameter
Parameter
snapImage
Description
The name of the remote replication group for
which you want to start synchronization. Enclose
the remote replication group name in double
quotation marks (" ") inside square brackets ([ ]").
The parameter to delete the recovery point if the
recoverable synchronization data has exceeded
time threshold for recovery. Recovery point age is
measured from the time the data was frozen on
the primary storage array.
Description
The name of the snapshot image for which you
want to restart a rollback operation. The name of a
snapshot image is comprised of two parts:
• The name of the snapshot group.
• An identifier for the snapshot image in the
snapshot group.
The identifier for the snapshot image can be one of
these:
• An integer value that is the sequence number
of the snapshot in the snapshot group.
249