Table of Contents
Advertisement
Show Remote Replication Group Synchronization
Progress
Description
This command displays the progress of periodic synchronization of the remote replication group
between the local and remote storage array. This command returns the progress of data synchronization
on all of the replicated pairs within the remote replication group. This command shows the progress as a
percentage of data synchronization that has been completed.
NOTE: There are two types of synchronization: initial synchronization and periodic synchronization.
Initial remote replication group synchronization progress is displayed in the Long Running
Operations dialog and by executing the show storageArray longRunningOperations
command.
Syntax
show
asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"]
[synchronizationProgress]
Parameters
Parameter
asyncRemoteReplicationGroup
synchronizationProgress
Show Remote Replication Virtual Disk Candidates
Description
NOTE: This command valid only with Fibre Channel storage arrays.
This command returns information about the candidate virtual disks on a remote storage array that can
be used as secondary virtual disks in a Remote Replication configuration.
332
Description
The name of the remote replication group for
which you want to check the synchronization
progress. Enclose the remote replication group
name in square brackets ([ ]). If the remote
replication group name has special characters, you
also must enclose the remote replication group
name in double quotation marks (" ") inside square
brackets. If the remote replication group name
consists only of numbers, such as "1002," you also
must enclose the remote replication group name
in double quotation marks (" ") inside square
brackets.
Use this optional parameter to display the periodic
synchronization progress of the remote replication
group.
Advertisement
Table of Contents
