Recopy Virtual Disk Copy - Dell PowerVault Manual

Recopy Virtual Disk Copy

Description
This command reinitiates a virtual disk copy operation by using an existing virtual disk copy pair.
NOTE: See Preparing Host Servers To Recopy A Virtual Disk.
CAUTION: Before you create a new copy of a source virtual disk, stop any data access (I/O)
activity or suspend data transfer to the source virtual disk and (if applicable, the target disk) to
ensure that you capture an accurate point-in-time image of the source virtual disk. Close all
applications, including Windows Internet Explorer, to make sure all I/O activity has stopped.
NOTE: Removing the drive letter of the associated virtual disk(s) in Windows or unmounting the
virtual drive in Linux helps to guarantee a stable copy of the drive for the virtual copy.
Syntax
recopy virtualDiskCopy target [targetName]
[source [sourceName]]
[copyPriority=(highest | high | medium | low | lowest)
targetReadOnlyEnabled=(TRUE | FALSE)]
copyType=(online | offline)
Parameters
Parameter
target
source
copyPriority
228
Description
Name of the target virtual disk for which to
reinitiate a virtual disk copy operation. You must
put brackets ([ ]) around the target virtual disk
name. If the target virtual disk name has special
characters, you must also put quotation marks (" ")
around the target virtual disk name.
Name of the source virtual disk for which to
reinitiate a virtual disk copy operation. You must
put brackets ([ ]) around the source virtual disk
name. If the source virtual disk name has special
characters, you must also put quotation marks (" ")
around the source virtual disk name.
Specifies the priority that the virtual disk copy has
relative to host I/O activity. Valid entries are
highest, high, medium, low, or lowest.