Set Snapshot Group Attributes - Dell PowerVault Manual

Set Snapshot Group Attributes

Description
This command defines the properties for a snapshot group.
Syntax
set snapGroup ["snapGroupName"]
[userLabel="snapGroupName" |
repositoryFullPolicy=(failBaseWrites | purgeSnapImages) |
repositoryFullLimit=percentValue |
autoDeleteLimit=numberOfSnapImages |
rollbackPriority=(lowest | low | medium | high | highest)
Parameters
Parameter
snapGroup
userLabel
repositoryFullPolicy
repositoryFullLimit
autoDeleteLimit
rollBackPriority
Description
The alphanumeric identifier (including - and _) of
the snapshot group for which you are setting
properties. Enclose the snapshot group name in
double quotation marks (" ") inside of square
brackets ([ ]).
The new alphanumeric identifier (including - and _)
that you want to give to the snapshot group. Use
this parameter when you want to rename the
snapshot group. Enclose the new snapshot group
name in double quotation marks (" ").
How you want snapshot image processing to
continue if the repository virtual disks for the
snapshot image group are full. You can choose to
fail writes to the base virtual disk
(failBaseWrites) or delete (purge) the snapshot
images (purgeSnapImages). The default action is
purgeSnapImages.
The percentage of repository virtual disk capacity
at which you receive a warning that the snapshot
image repository virtual disk is nearing full. Use
integer values. For example, a value of 70 means
70 percent. The default value is 75.
The maximum number of snapshot images that
you want to automatically delete if you have
selected to purge the snapshot images for a
repository full policy. Use integer values. The
default value is 32.
Use this parameter to determine whether system
resources should be allocated to the rollback
293