Dell PowerVault Manual page 180

Parameter
remoteStorageArrayName
remoteStorageArrayWwn
remotePassword
syncPriority
autoResync
writeOrder
writeMode
Notes
Names can be any combination of alphanumeric characters, hyphens, and underscores. Names can have
a maximum of 30 characters.
When the primary virtual disk and the secondary virtual disk are chosen, the secondary virtual disk must
be of equal or of a greater size than the primary virtual disk. The RAID level of the secondary virtual disk
does not have to be the same as that of the primary virtual disk.
Passwords are stored on each storage array in a management domain. If a password was not previously
set, a password is not needed. The password can be any combination of alphanumeric characters with a
maximum of 30 characters. (A storage array password can be defined by using the set storageArray
command.)
Synchronization priority defines the amount of system resources that are used to synchronize the data
between the primary virtual disk and the secondary virtual disk of a replication relationship. If the highest
180
Description
The name of the remote storage array. Enclose the
remote storage array name in double quotation
marks (" ").
The World Wide Identifier (WWID) of the remote
storage array. Enclose the WWID in double
quotation marks (" ").
The password for the remote storage array. Use
this parameter when the remote storage array is
password protected. Enclose the password in
double quotation marks (" ").
The priority that full synchronization has relative to
host I/O activity. Valid values are highest, high,
medium, low, or lowest.
The settings for automatic resynchronization
between the primary virtual disks and the
secondary virtual disks of a remote replication pair.
This parameter has these values:
• enabled—Automatic resynchronization is
turned on. You do not need to do anything
further to resynchronize the primary virtual disk
and the secondary virtual disk.
• disabled—Automatic resynchronization is
turned off. To resynchronize the primary virtual
disk and the secondary virtual disk, you must
run the resume remoteReplication
command.
The write order for data transmission between the
primary virtual disk and the secondary virtual disk.
Valid values are preserved or notPreserved.
How the primary virtual disk writes to the
secondary virtual disk. Valid values are
synchronous or asynchronous.