Programming The Mmsi - Standard Horizon Eclipse GX1300 Owner's Manual

9.2.2 Programming the MMSI

The MMSI can be input only once. Therefore, please be careful
not to input the incorrect MMSI number. If you need to change the
MMSI number after it has been entered, the radio will have to be re-
turned to Factory Service. Refer to the section "12.2 FACTORY SER-
VICE."
1. Press the MENU key to display the menu.
2. Press the ▲ / ▼ key to select " MMSI/POS
INFO ".
SELECT
3. Press the
BACK
the soft key.)
4. Press the ▲ / ▼ key to select the first number
of your MMSI, then press the
to step to the next number.
5. Repeat step 4 to set your MMSI number (nine
digits).
6. If a mistake was made entering in the MMSI
number, press the ◄ / ► key until the wrong
number is highlighted, then press the ▲ / ▼
key to correct the entry and press the
soft key.
7. W h e n f i n i s h e d p r o g r a m m i n g t h e M M S I
number, press the
will ask you to input the MMSI number again.
Use steps 4 through 6 above.
8. After the second number has been input, press
FINISH
the soft key to store the MMSI.
OK
9. Press the
POS INFO " screen.
10. Press the 16/S key or press the
tion mode.
GX1300
WARNING
soft key. (To cancel, press
FINISH
soft key. The radio
soft key to return to the " MMSI/
SELECT
soft key
SELECT
BACK
soft key to return to radio opera-
BACK SELECT
MMSI INPUT
1st:
---------
BACK FINISH SELECT
MMSI INPUT
1st:
366901234
BACK FINISH SELECT
MMSI INPUT
1st:
*********
2nd:
366901234
BACK FINISH SELECT
MMSI INPUT
STORED MMSI
366901234
OK
Page 37