Sending A Hookflash While On A Call; To Send A Hookflash Signal To A Co Or A Pbx; Extension Reset; To Reset Your Digital Telephone Set - Inter-Tel 3000 Administration Manual

Inter-Tel 3000
Administrator's Manual

SENDING A HOOKFLASH WHILE ON A CALL

A Hookflash signal can be required if you are using certain network services on standard CO lines, or if
your Inter-Tel 3000 is connected to another telephone system (PBX) via one of the line interfaces.
The Hookflash feature allows you to send a hold signal forward on the line to the CO or PBX. To send a
hold signal, you must be on a call or have dialed at least one digit of the number you are calling.

To Send a Hookflash Signal to a CO or a PBX

•
From a digital telephone set, select "Hookflash" on the display.
From a standard analog phone, the code is Hookflash 780.

EXTENSION RESET

You can reset your extension to cancel all the following features if they have been set:
•
Do-Not-Disturb.
•
Call Forward.
•
Call Back.
•
Display Messaging.
•
Reminder Call

To Reset your Digital Telephone Set

•
From the Idle Menu, press the Scroll Down key ( ) until "Reset The Telephone" is displayed.
•
Select "Reset the Telephone". The display shows "Extension Reset" momentarily before returning to
the idle menu.
If you are using a standard analog phone, dial 739 and wait for the acknowledgment tone (internal dial
tone).

SETTING THE TIME AND DATE

•
From the Programming extension, press the PROGRAM key
•
Press the Scroll Down key ( ) until "System Programming" is displayed
•
Select "System Programming"
•
Enter the System Programming Password and select "System".
•
Select "Time and Date"
•
Enter the correct time in 24-hour format (e.g., 2pm as 1400). The display will prompt for a date.
•
If you only wish to set the time, select "Confirm" and the display will revert to the idle menu.
•
Enter the date in mm/dd/yy format (e.g., December 10 2002 as 121002). When the date has been
entered, the display will revert to the idle menu.
Press the speakerphone key to finish programming.
Note: In the event of a power failure, you will need to reset the time and date.
Note: Changes to the system Time will only take place when any external calls in progress at that time have
cleared.
Note: If the Caller ID feature has been presented by the network, the time, day, month will be update after
3:00 AM each day when the first outgoing call is made or the first incoming call with Caller ID information
rings on the system.
83