Customer Owned Coin/Credit Card Phones; Data Equipment; Systems; Adjuncts - Kx And Px Devices - Inter-Tel 3000 Administration Manual

Customer Owned Coin/Credit Card Phones

To comply with state tariffs, the Telephone Company must be given notification prior to connection. In
some states, the state public utility commission, public service commission or corporation commission
must give prior approval of connection.

Data Equipment

The table below shows which jacks are associated with which modes of operation:

Systems

Facility Interface Codes (FIC), Service Order Codes (SOC), USOC Jack Codes and Ringer Equivalence
Numbers (REN) are shown in the table below for each port where applicable:
Port
PSTN
ISDN _PRI
ADSL
Adjuncts – KX and PX Devices
When this adjunct is used with a leased system, permission of the owner should be requested for
connection of the adjunct.
KX-type telephones with message waiting lights and/or line status indicators can only be connected to host
equipment and never directly to the network.
KX devices can only be installed with the permission of the owner of the host equipment as "surgery" is
often required on the host system.

OEM Devices

The mounting of the certified unit in the final assembly must be made so that the certified unit is isolated
from exposure to any hazardous voltages within the assembly. Adequate separation and restraint of cables
and cords must be provided.
The circuitry from the certified unit to the telephone line must be provided in wiring that carries no other
circuitry unless specifically allowed by the rules (such as PC and PR leads). PC board traces carrying tip
and ring leads shall have sufficient spacing to avoid surge breakdown.
If the certified device is enclosed in an assembly, and is not readily accessible, the certification label must
be placed on the exterior of the cabinet for each type of certified device contained therein.
The final assembler must provide all applicable material (contained in this section) with the final
equipment. A modular plug or jack must be provided which complies with Part 68, Subpart F requirements
for dimensions, tolerances and metallic plating.

Warning

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in
strict accordance with the manufacturer's instructions, can cause interference to radio and television
reception. It has been type tested and found to comply with the limits for a Class A computing device in
accordance with the specifications in Subpart J of Part 15 of the FCC Rules. Operation of this equipment in
a residential area can cause unacceptable interference to radio and TV reception requiring the operator to
take whatever steps are necessary to correct the interference. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause interference to radio or
Mode of Operation
Permissive
Programmable
FIC
9.0Y
2
Administrator's Manual
USOC Jack
RJ11C
RJ41S and RJ45S
SOC USOC Jack
02LS2 RJ11
RJ45
RJ11
Inter-Tel 3000
REN
0.9B