Installing The Front Bezel Assembly; Installing Or Removing A Server Board; Figure 14. Installing The Front Bezel Assembly (Dp/Ws/Brp Configuration Shown) - Intel SC5650-DP Service Manual

Hardware Installations and Upgrades

Installing the Front Bezel Assembly

1. Line up the three clips on the right side of the front bezel assembly with the
corresponding slots on the right side of the chassis (see letter "A" in the following
figure). Engage the clips with the slots (see letter "B"). Rotate the left side of the front
bezel assembly towards the chassis (see letter "C"). Snap the two bezel tabs into the
corresponding recesses at the left edge of the chassis front panel (see letter "D").

Figure 14. Installing the Front Bezel Assembly (DP/WS/BRP configuration shown)

2. Reinstall the left side cover. For instructions, see
3. Reconnect all peripheral devices and the AC power cable. Power up the server.

Installing or Removing a Server Board

Note: The type of Intel
chassis you purchased. For a breakout of server board/chassis model compatibility, see
Table 1, "Breakdown of Intel® Server Chassis SC5650
To install or remove a server board, do the following:
1. Observe the safety and ESD precautions listed in
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the left side cover. For instructions, see
4. Remove the front bezel assembly. For instructions, see
Assembly".
18
D
A
D
C
®
Server Board you can install in your chassis depends on the model of
A
A
A
B
"Installing the Left Side
Configurations".
Appendix A, "Safety
"Removing the Left Side
"Removing the Front Bezel
®
Intel Chassis SC5650-DP/WS/BRP/UP Service Guide
TP02035
Cover".
Information".
Cover".