Installing The Sas/Pcie* Sff Combo Bridge Board; Replacing The Server Board; Removing The Server Board; Figure 61. Installing The Sas/Pcie* Sff Combo Bridge Board - Intel S2600TP series Service Manual

Intel® Server Board S2600TP and Intel® Compute Module HNS2600TP Product Family
2.13.2

Installing the SAS/PCIe* SFF Combo Bridge Board

1. Attach the plastic holder to the front end of the bridge board (see letter A).
2. Insert the bridge board into the slots on the server board (see letter B).
3. Secure the bridge board to the side wall with the six screws (see letter C).

2.14 Replacing the Server Board

2.14.1

Removing the Server Board

1. Remove the air duct. See
2. Remove the processors and the memory DIMMs if there are any. See
Removing the Memory.
3. Remove the bridge board. See
4. Remove the PCIe* riser assembly from the riser slot 1. See
and Removing the PCIe* Riser Assembly – Step
5. Remove the IOM riser and carrier assembly from the riser slot 2 if there is any. See
Riser and Carrier Assembly.
6. Disconnect the cables from the server board.
30
Figure 61. Installing the SAS/PCIe* SFF Combo Bridge Board
Removing the Air
Removing the Bridge
Duct.
Board.
Removing the PCIe* Riser Assembly – Step 1
2.
Removing the Processor
Removing the IOM
and