For more information about the configuration of other timers in PIM-DM, see
PIM
timers."
Configuring PIM-SM
This section describes how to configure PIM-SM.
PIM-SM configuration task list
Tasks at a glance
(Required.)
(Required.)
•
Configuring a static RP
•
Configuring a C-RP
•
(Optional.)
Configure a BSR:
•
(Required.)
•
(Optional.)
•
(Optional.)
(Optional.)
(Optional.)
(Optional.)
Configuration prerequisites
Before you configure PIM-SM, configure a unicast routing protocol so that all devices in the domain
can interoperate at the network layer.
Enabling PIM-SM
Enable IP multicast routing before you configure PIM.
With PIM-SM enabled on interfaces, routers can establish PIM neighbor relationship and process
PIM messages from their PIM neighbors. As a best practice, enable PIM-SM on non-boarder
interfaces of routers when you deploy a PIM-SM domain.
IMPORTANT:
All the interfaces on the same router must operate in the same PIM mode in the public network or
the same VPN instance.
To enable PIM-SM:
Step
Enter system view.
1.
Enable IP multicast routing
2.
and enter MRIB view.
Enabling PIM-SM
Configuring an
RP:
Enabling Auto-RP listening
Configuring a C-BSR
Configuring a PIM domain border
Disabling BSM semantic fragmentation
Configuring multicast source registration
Configuring the switchover to SPT
Configuring common PIM features
Command
system-view
multicast routing
[ vpn-instance
vpn-instance-name ]
110
"Configuring common
Remarks
N/A
You must configure a static RP, a C-RP, or
both in a PIM-SM domain.
Skip the task of configuring a BSR on a
network without C-RPs.
N/A
N/A
N/A
Remarks
N/A
By default, IP multicast routing is
disabled.