Communication Test - IDTECK STAR 505R User Manual

STAR 505R
Scanning . . .
Reader 1
00312345
Reader No.
Card No.
14.4.7 Input TEST
INPUT TEST
INPUT TEST
11111
INPUT 1

14.4.8 Communication TEST

COMM TEST
TX data = 0
COMM fail
COMM test pass ! !
Press any key . . .
505R-20011128
The reader is waiting for an RF card to read. Present an RF card to
the reader.
The test has completed successfully if the LCD displays the ID card
number (example shown to left).
To test the performance of input ports , press <ENT> key.
The lower line on the LCD indicates the status of the five input signals.
Note: 1. Input 1~4 : '0'=ON , '1'=OFF
2. Input 5
Before this communication test, connect the RS-232 Rx, Tx wires to
each other. And to begin the test, press <ENT> key.
This message indicates there is a problem with the communication
performance. Check connections and try again. Press any key to return
to the setup menu.
As the test proceeds, you can see the characters being transmitted
and received. This message indicates that the communication test has
succeeded.
42
ACCESS CONTROLLER
: '0'=OFF, '1'=ON
ID TECK