IDTECK STAR 505R User Manual page 38

STAR 505R
14.3.4 Counting Registered IDs
REGISTERED ID
XXXXX
14.3.5 Setting Possible Registration ID Count
ID COUNT
ID COUNT
500
ENTER ID COUNT
[_ _ _ _ _]
EVENT MEMORY
NOT EMPTY !!!
ID TOTAL COUNT
Wrong !!!
505R-20011128
This menu displays the total number of registered IDs count.
EVENT MEMORY
'ENT'
EMPTY ?
NO
DISPLAY EVENT MEMORY
NOT EMPTY
DISPLAY INVALID COUNT
DISPLAY ID TOTAL COUNT
You should choose which possible registration ID count is to be applied.
The default count is "500"(up to 7,250 events can be stored off-line.).
If necessary, press <ENT> key.
This figure appears When you press the <ENT>key(and event memory is
empty or not used). You are to enter a new upper limit of ID registration
which must be a multiple of 500.
You'll see this message when the event memory have been used and it's
not empty. You can try again after uploading the data to the host or deleting
them, using the setup mode F1(14.1.7 event clear).
This message will show when the entered number is less than the total
number of the registered IDs. If you want to delete some of the IDs and
reduce the possible registration ID count, clear the ID memory, using the
setup mode F1 first and try again from the beginning.
YES
NO
NO
WRONG !!!
38
ID TECK
ACCESS CONTROLLER
ENTER NO. (3 ~ 5 digit)
ID COUNT VALID ?
YES
REGISTERED ID COUNT
< ENTER NO. ?
YES
COMPLETE