IDTECK STAR 505R User Manual page 27

STAR 505R
14.1.13 Selecting event memory use or not use
EVENT MEMORY
NOT USE
EVENT MEMORY
-->USE
14.1.14 Setting Duress Mode
DURESS MODE SET
NOT USE
DURESS MODE SET
--> USE
DURESS P/W
00
DURESS P/W
00
505R-20011128
You can select whether the Stand Alone is used or not. The lower line on
the LCD indicates the current mode. Press <4> or <6> to toggle the mode,
from NOT USE to USE or the reverse, and finish selecting by pressing
<ENT> key.
Note: If you select NOT USE, then system will not display event full
message.
DURESS MODE SET
'ESC'
DISPLAY CURRENT P/W
'ENT'
ENTER NEW P/W
( 2 digit + ENT)
You can select whether the Duress mode is used or not. The lower line on
the LCD indicates the current mode.
To change mode, press <ENT> key.
If you select USE, then system displays the current DURESS P/W. To
change P/W, press <ENT> key.
Note: You can set the duress output in setup menu F2 ( in/out define ). In
case of Duress, enter the 2 digit Duress Password and press <ENT> and
open the door using general process. If you registered ID, then duress
output(see 14.2.3) will be generated.
'ENT' NOT USE(DEFAULT)
SELECT KEY(4 or 6 keys)
IF DURESS MODE USED
DURESS P/W
27
ID TECK
ACCESS CONTROLLER
USE