IDTECK STAR 505R User Manual page 40

STAR 505R
14.4.1 VERSION
VERSION
F/W : Rev. 3.5
14.4.2 SRAM TEST
SRAM TEST
Memory fail !!! 0
RAM testing...
RAM test pass ! ! !
Press any key . . .
14.4.3 Outputs TEST
OUTPUT TEST
'ANY KEY'
505R-20011128
The version of the controller's firmware is displayed on the LCD.
Press <4> or <6> key to look for other menus of setup menu F4.
To test the memory, press <ENT> key.
This message would indicate the SRAM has problems. In this event,
contact technical support. Press any key to return to the setup menu.
Use <4> key and <6> key for testing other performances.
This message appears when the SRAM is operating normally. Press
any key to return to the setup menu. Use <4> key and <6> key for testing
other performances.
RELAY 1 TEST
'ENT'
(REPEAT ON/OFF TWO TIMES)
RELAY 2 TEST
(REPEAT ON/OFF TWO TIMES)
TTL OUTPUT 1 TEST
(REPEAT ON/OFF TWO TIMES)
TTL OUTPUT 2 TEST
(REPEAT ON/OFF TWO TIMES)
BUZZER TEST
(REPEAT ON/OFF TWO TIMES)
OUTPUT TEST END
40
ID TECK
ACCESS CONTROLLER
This test is applicable to
Relay1 and blue led.
This test is applicable to
Relay2 and yellow led.
This test is applicable to
TTL1 output.
This test is applicable to
TTL2 output.
This test is applicable to
Buzzer output.