IDTECK STAR 505R User Manual page 26

STAR 505R
14.1.9 Initializing the System
SYS INITIALIZE
Sys Initializing
1 - Yes , 0 - No
System
Initializing..
14.1.10 Clearing Card IDs
CARD ID CLEAR
Card ID Clear
1 - Yes , 0 - No
14.1.11 Clearing Time Schedule
TIME SCHE CLEAR
TIME SCHE CLEAR
1 - Yes , 0 - No
14.1.12 Selecting ID Input mode
RF_PIN_INPUT
ENABLE
505R-20011128
This operation will initialize the STAR 505R. Press <ENT> key, if an
initialization is needed (first time installation or resetting in the event of a
malfunction).
CAUTION: Initializing will erase all stored data incl. registered IDs
event data
When this figure appears on the LCD, press <1> key to clear and <0> key
to cancel the operation, then the LCD displays the first figure of this menu.
This message appears while the system is being initialized. When
finished, you will be automatically returned to the setup menu.
Used to erase ALL the registered card ID data stored in the device.
If you want to do so, press <ENT> key.
When this figure appears on the LCD, press <1> key to clear and <0> key
to cancel the operation, then the LCD automatically returns to the start
menu.
CAUTION: This function will remove ALL registered ID cards.
Used to erase ALL the time schedules. If you want to do so, press <ENT>
key.
CAUTION: This function will erase ALL programmed time schedules
When this figure appears on the LCD, press <1> key to clear and <0> key
to cancel the operation, then the LCD automatically returns to the start
menu.
You can enable PIN(card number) to be input through the keypad, so that
someone who doesn't carry RF cards with him can access the door. When it
is disabled, accessing the door by keypad will be denied.
The display shows the current mode. Press <ENT> key to toggle the mode.
26
ACCESS CONTROLLER
.
ID TECK
.