Installation Of The Product - IDTECK STAR 505R User Manual

STAR 505R

7. Installation of the Product

7-1. Tear off page 46 and use the provided template to drill two 6-32 holes and one 1/2" hole on the
proper location of the wall to mount the Wall Mount bracket as shown below.
( If the gang box is already installed on the wall then skip this step.)
7-2. Using 2 screws, install wall mount to the wall.
* CAUTIONS *
Before mounting the STAR 505R unit to the Wall Mount bracket, operational test of the unit
should be completed, as the locking pins will lock the unit to the Wall Mount. Removing the
unit from the Wall Mount bracket after they have been installed together may cause damages
to the bracket and render its effectiveness.
7-3. Insert 5 O-rings to the wall mount as indicated, then route the cable of the main unit through the
center hole and push the main unit to wall mount to lock the main unit and make sure that the
main unit is locked with wall mount.
505R-20011128
7
ID TECK
ACCESS CONTROLLER