IDTECK STAR 505R User Manual page 22

STAR 505R
14.1.1 Changing Reader1 Operating Mode
MODE SELECTION
READER1 MODE
RF ONLY
READER1 MODE
--> RF ONLY
READER1 MODE
--> RF + PW
READER1 MODE
--> PIN
14.1.2 Changing Reader2 Operating Mode
READER2 MODE
RF ONLY
READER2 MODE
--> RF ONLY
READER2 MODE
--> RF + PW
505R-20011128
'ENT' RF Only (DEFAULT)
SELECT KEY(key <4> or <6>)
RF+P/W( PassWord 4 digit )
SELECT KEY(key <4> or <6>)
PIN (4 ~ 6 digit)
This menu is to select reader1 operating mode. You may choose to use
prox, PIN # verification, or both. The lower line on the LCD indicates the
current operating mode. Press the <ENT> key to change the mode.
Then, this figure appears on the LCD, press <4> key or <6> key to toggle
the mode, and finish selecting by pressing <ENT> key.
For the next setting, use <4> and <6> keys.
Note: RF only : The door is accessible with the card alone.
RF + PW : To access the door, the card and the password is
PIN : The door is accessible with the Identity
Number(4~6 digit) by the keypad
This menu is to select reader2 operating mode. You can choose whether
to use password to each access or not. The lower line on the LCD indicates
the current operating mode. Press <ENT> key to change the mode.
Then, this figure appears on the LCD, press <4> key or <6> key to toggle
the mode, and finish selecting by pressing <ENT> key. For the next setting,
use <4> and <6> keys.
22
needed.
ID TECK
ACCESS CONTROLLER
Error message:
ID memory not empty!!!