IDTECK STAR 505R User Manual page 15

STAR 505R
13.2 System Initialization by means of Hardware
Connect the cyan wire, pink wire and black wire(they are seen from the rear view) together and
Power on the unit. Power off and disconnect the wires.
13.3 Enter into setup menu
NO
ERROR STATUS
NO
505R-20011128
POWER ON
"Initialize END"
"Turn OFF Power..."
Turn off Power
System initialization completion
INITIAL DISPLAY
(MODEL NAME, CURRENT TIME)
ID INPUT ?
YES
MASTER ID ?
YES
SETUP MODE
If you turn on the system
power after connecting 3 wires
(pink, cyan and black (GND)),
you can enter into system
initialize mode.
Disconnect the 3 wires
( pink, cyan, black ) .
To set or to change the STAR 505R access
controller's operation, enter the eight-digit
Master number (factory setting "00000000" )
or CARD.
Note You can change the Master ID. (see 14.1.8)
NO
OPERATE GENERAL
MODE
15
ID TECK
ACCESS CONTROLLER
Operation of Registered ID
Operation of Unregistered ID
Operation of Duress mode