Performing Selective Transfer; Preparing The Receiver Printer; Preparing The Sender Printer - Intermec 4630 User Manual

Cloning is now complete. Disconnect the serial cable from the receiver printer.
To clone another printer
1. Use the menu panel on the new printer to designate it as the receiver
2. Connect the main serial port of the receiver printer to the serial cable
3. Press Enter on the sender printer menu panel.

Performing Selective Transfer

If you want to copy select fonts, formats, graphics, or pages from one printer to
another printer, but you do not want to clone the entire RAM contents, you can
use the Selective Transfer command. Use this command to set up different
printers to print the same label formats.
Note: The receiver printer must have enough RAM to accommodate the information
downloaded from the sender printer.

Preparing the Receiver Printer

Configure the receiver printer with the following communication settings:
•
•
•
•

Preparing the Sender Printer

1. Connect the main serial ports of the sender and the receiver printers with
2. From the OFFLINE READY display of the sender printer, press Menu and
The receiver printer display shows:
CLONING
RECEIVER
printer.
attached to the sender printer.
9600 baud
7 data bits
Even parity
1 stop bit
an RS-232 null modem serial cable (Intermec P/N 049353).
then press ↑ or ↓ until you reach the Service menu.
7
Special Procedures
7-5