Cleaning The 4630 Standard Cutter Assembly; Cleaning The Printer Cover - Intermec 4630 User Manual

4630 and 4830 Bar Code Label Printers User's Manual

Cleaning the 4630 Standard Cutter Assembly

The 4630 standard cutter is designed to cut non-
adhesive media that does not exceed a thickness
of 0.0075" (0.190 mm). The cutter requires a
minimal amount of maintenance; however, it
produces dust and paper particles as it operates
and must be cleaned periodically to ensure
proper performance. Clean the cutter of debris
buildup after every 100,000 cuts. The cutter
assembly has a life expectancy of 500,000 cuts.
To clean the cutter assembly
1. Disconnect the cutter power cable from the
2. Remove the Phillips screw that secures the upper cover to the cutter
3. Use a cotton swab moistened with isopropyl alcohol to clean the cutter
4. Use compressed air to remove dust and paper particles from the cutter
5. Replace the upper cutter cover and secure it to the cutter assembly.
6. Install the cutter assembly on the printer and then connect the cutter power

Cleaning the Printer Cover

Clean the printer cover with a general purpose cleaner (soapy water/mild
detergent). Do not use abrasive cleansers or solvents. Be sure to clean the
transparent panel on the stock door so that the media supply inside the printer
is visible when the cover is closed.
3-8
bottom of the cutter assembly and then
remove the cutter assembly from the printer.
assembly and then remove the upper cover.
blade of adhesive buildup.
Warning
Use extreme caution when cleaning the cutter to avoid cutting yourself.
Avertissement
Lors du nettoyage de la barre coupante, prenez bien soin de ne pas vous
couper.
mechanism.
cable to the cutter assembly.