Understanding Error Messages - Intermec PF2i User Manual

Understanding Error Messages

Fingerprint Error Messages
Message Description
If you perform a user break by pressing S - P to
Application
break stop an application from running, or if a runtime
error occurs, the Intermec Ready-to-Work indicator
turns off. You can turn the indicator on by changing
to Direct Protocol or running an application.
But, if the application handles the break (ON
BREAK) or runtime error (ON ERROR GOTO), the
Intermec Ready-to-Work indicator is not affected,
and the application sets the status. For more
information, see the
Reference
Application If an application is started but does not run, the
load error Intermec Ready-to-Work indicator blinks. For
example, if there is a syntax error in the loaded
program file.
Cutter does Open and shut the cutter.
not respond
Cutter error1 Open and shut the cutter.
Cutter error2 Open and shut the cutter.
Cutter error3 Open and shut the cutter.
Cutter open Shut the cutter.
Generic DP In Direct Protocol, you can enable error handling for
error specific errors using the ERROR statement. When
errors added to the built-in error handling occur, this
event is set. The text included in the SNMP trap is
the standard text corresponding to the error.
Head lifted The printhead is lifted. Lower the printhead.
PF2i and PF4i Mid-Range Printer User's Manual
Chapter 4 — Troubleshooting and Maintaining the Printer
Use the following tables to troubleshoot common error messages you
may see displayed on your printer's screen. Keep in mind that some
error messages:
• are specific to the type of firmware you are running.
• have corresponding error numbers.
cause the Intermec Ready-to-Work indicator to blink or turn off.
•
Intermec Fingerprint Command
Manual.
Ready-to-Work Error
Indicator Status Number
Off
Blinking
Blinking 1059
Blinking 1701
Blinking 1702
Blinking 1703
1704
Blinking
Blinking 1022
95