Intermec 4630 User Manual page 53

To route media through the self-strip assembly
1. Load the printer with die-cut media and feed it through the printer until
approximately 18 inches (46 mm) of media extend from the front of the
printer.
2. Pull open the roller bracket using the two release tabs and then thread the
media over the top of the fixed bracket, under the rollers of the roller
bracket, and into the media take-up slot.
3. Connect the media to the media rewind hub. Refer to "Using the Media
Rewind Hub" earlier in this chapter for more information.
Operating and Configuring the Printer
2
2-19