Understanding Error Mode; Understanding Test Mode; Using Test Mode - Intermec PW50 User Manual

Chapter 2 — Configuring the PW50

Understanding Error Mode

Understanding Test Mode

20
To cancel a print job
1 Press the Feed button to pause printing.
2 Press and hold the Feed button to cancel the print job.
The printer enters Error mode when it detects an error condition such
as a low battery or a paper fault. When the printer is in Error mode,
the status LED blinks red.
Use Test mode to verify printer settings, print testprints, restore
factory default settings, or enter Dump mode for troubleshooting
purposes. Two test modes are available: Test mode and Extended Test
mode.

Using Test Mode

Test mode consists of a sequence of events that requires very little
interaction. Extended Test mode requires more interaction and lets
you choose which actions you want the printer to perform.
To enter Test mode
1 Make sure the PW50 is in Standby mode and is loaded with media.
2 Press and hold the Standby and Feed buttons until the PW50
beeps.
PW50 Workboard Printer User's Guide