Ttr/Direct Thermal Media Grade, Select; Program Mode Commands - Intermec 4630 User Manual

TTR/Direct Thermal Media Grade, Select

Selects the label stock to be used.
Purpose:
Syntax:
<SI>g n
n = 0
n = 1
n = 0
Default:
Notes: This command becomes effective after a printer reset or power up.

Program Mode Commands

The Program mode commands are used specifically for label format design and
to download user-defined fonts and graphics. To set the printer to Program
mode, send the following command string:
<STX><ESC>P<ETX>
When creating or editing formats, the printer uses a field pointer to designate
the field that is to be modified when the printer is in Program mode. In order
to download commands in Program mode, you must specify the field to be
changed. If you do not select a field, the pointer will continue to point to the
last selected field until a different format or field is selected.
New formats contain a default human-readable field numbered H0. New pages
do not contain a default format.
Note: Each string of commands must be preceded by the start of message character
<STX>, and followed by the end of message character <ETX>. The semicolon (;) is the
command terminator. All commands in Program mode must end with this terminator
except the last command in a message. Parentheses {( )} and <LF> characters are
ignored by the printer in Program mode.
The following command descriptions explain the commands that are effective
when the printer is in Program mode. The command descriptions are listed in
alphabetical order.
Direct thermal stock
Thermal transfer stock
Configuration Commands
6
6-37