Setting The Media Alert - Intermec 4630 User Manual

4630 and 4830 Bar Code Label Printers User's Manual

Setting the Media Alert

Command
Media Length
Low Media Warn
Set Warning
2-24
To change the label configuration settings
1. From the OFFLINE READY display, press Menu and then press ↑ or ↓
until you reach the Configuration menu.
2. Press Select and then press ↑ or ↓ until the display shows:
CONFIGURATION
LABEL
3. Press Select and then press ↑ or ↓ to scroll through the available commands.
4. Press Select when you reach the command you want. The display shows
the current setting for the command.
5. Press ↑ or ↓ to scroll through the available settings for that command.
6. Press Enter when you see the setting you want. An asterisk (*) appears next
to the new setting, indicating it is active.
7. Press Cont to return to the OFFLINE READY display or, to change other
configuration settings, press Menu and repeat Steps 3 through 6.
The Media Alert feature flashes the Alert light to warn you when the media
supply is getting low.
Note: You need to reset the Media Length and the Low Media Warn commands each
time you load a different size roll of media into the printer. If you do not, the printer
may not give you sufficient warning of a low media condition.
To use Media Alert, you must set three control panel commands. An asterisk
(*) indicates the default values.
Settings
0* to 99999 inches or
0* to 2539975 mm
0* to 999 inches or
0* to 25375 mm
Enabled, Disabled*
Description
The media supply length in inches or millimeters. The
printer uses this value to count backwards (down) to the
low media warning point.
The minimum amount of media supply. When the
media supply reaches this amount, the alert light is
activated.
Enable or disable the Media Alert feature.