Intermec 4630 User Manual page 79

Error Message
PARAMETER ERROR
36
PARAMETER ERROR
38
PRINTHEAD COLD
PRINTHEAD HOT
PRINTHEAD TEMP
SENSOR FAULT
RANGE ERROR 12
RANGE ERROR 21
RANGE ERROR 22
RANGE ERROR 23
RANGE ERROR 52
Problem
Invalid or undefined format or page
number.
Invalid or undefined field number.
The printhead is too cold to print
properly.
The printhead is too hot to print.
The temperature sensor for the
printhead is not working or is
disconnected.
Data count has been exceeded.
Quantity or batch count is out of
range.
Increment or Decrement quantity is
out of range.
Intercharacter delay or message delay
is out of range.
Invalid font/graphic height, width, or
intercharacter gap.
Troubleshooting
Solution
Verify that the page numbers are
between 0 and 9 and the format
numbers are between 0 and 19. Press
Cont to clear the alert.
Verify the field number in the label
format. Press Cont to clear the alert.
Wait for the printhead to heat up. At
the right temperature printing starts
automatically and the alert clears. If
the printer takes too long to heat up,
contact your Intermec representative.
Wait while the printhead cools. At the
right temperature, printing starts and
the alert clears. If the printer takes too
long to cool, or continues to overheat,
contact your Intermec representative.
The printer will continue to print, but
you cannot clear the alert. Contact
your Intermec representative.
Reduce the amount of data entered
into this field or increase the field's
maximum data (up to 200). Press Cont
to clear the alert.
Quantity of labels should be between 1
and 9999 and there should be 1 and
9999 batches of labels. Press Cont to
clear the alert.
Quantity should be between 1 and
9999. Press Cont to clear the alert.
Delay should be between 0 and 9999.
Press Cont to clear the alert.
Font or graphic height and width
should be between 1 and 600.
Intercharacter gap should be between
0 and 199 dots. Press Cont to clear the
alert.
4
4-9